ISO INTERNATIONAL STANDARD 13427 Second edition 2014-12-15 Geosynthetics Abrasion damage simulation (sliding block test) Géosynthétiques - Simulation de I'endommagement par abrasion (essai du bloc glissant) Reference number ISO 13427:2014(E) ISO International Organization for Standardization see=Zhejiang Institute of Standardization 5956617 @IS02014 vided by IHS under I No reproduction or networking permitted without license from IHS IS0 13427:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +4122 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland DrganizationforStandardization Not for Resale, 2015/3/11 02:19:09 networking permited withoutlicense from IHS IS0 13427:2014(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references 3 Terms and definitions 4 Principle 5 Apparatus 5.1 Abrasion tester. .1 6 Test specimens. .2 7 Conditioning ..2 8 Procedure ..2 9 Calculation and expression of results ..3 10 Test report ntemaonalganzatin4All rights reserved ii icenseeZhejiang Institute of Standardization 5956617 vided by IHS under I ed without license from IHS