ISO INTERNATIONAL STANDARD 26622-1 Secondedition 2017-04 Modular taper interface with ball track system - Part 1: Dimensions and designation of shanks Interfaces a cone modulaire avec systeme de serrage a billes - Partie 1: Dimensions et désignation des queues Reference number ISO 26622-1:2017(E) International Organization for Standardization @ IS0 2017 e=ZHEJIANG INSTOF STANDARDIZATION C1 5956617 nitted without license from IHS IS0 26622-1:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Internationai ibrg DrganizationforStandardization Licensee-ZHEJIANG INST OF STANDARDIZAISQ 017 - All rights reserVed networking permited without license from IHS IS0 26622-1:2017(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope.. 2 Normative references 3 Terms and definitions 4 Dimensions. 4.1 General 4.2 Tapered hollow shank 5 Clamping force 6 Designation Annex A (normative) O-rings. ..9 Annex B (informative) Recommendation for use and application ..10 Inteainal oganzation @st(Sar2a.47 - All rights reserved icensee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 ii vided by IHS under I se with ISt Not for Resale, 2017/8/21 01:39:33 ed without license from IHS