ISO INTERNATIONAL 2907 STANDARD Third edition 2002-08-15 Cinematography Maximum projectable image area on 35 mm motion-picture film - Position and dimensions Cinematographie-Surfacemaximaleprojetablepourune imagesurfilm cinematographique35mm-Positionetdimensions Reference number ISO 2907:2002(E) ISO @ISO2002 Copyright Intemational Organization for Standardization without license from IHS Not for Resale ISO 2907:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event ISO 2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ ISo 2002All rights reserved ted without ficense from IHS Not for Resale ISO2907:2002(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies(iSo committees. Each member body interested in a subject for which a technical committee has been established has liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEc Directives, Part 3 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO2907was prepared by Technical CommitteeISO/TC 36, Cinematography. This third edition cancels and replaces the second edition (isO 2907:1984), which has been technically revised. moandardaoed ili Copyright Inten Not for Resale a Not for Resale ISO 2907:2002(E) INTERNATIONALSTANDARD Cinematography Maximum projectable image area on 35 mm motion-picture filmPosition and dimensions Scope 35 mm motion-picture film and the position of this area relative to the perforations and the reference edge of the film. This International Standard specifies three types of image areas intended for theatrical projection (see A.4 in informative annex A): Style A: general theatrical release prints commonly referred to as non-anamorphic or wide screen; Style B: theatrical release prints with an anamorphic image; Style C: classic theatrical prints. 2 Position and dimensions of image area The dimensions shall be positioned as shown in Figure 1, and as specified in Table 1. NOTE1 Dimensions B, D, and E define the image area on the film that is available for projection.They do not define the opening in the projection-aperture plate. The size of this opening may differ from dimensions A and B, for example, because of rays accepted by the projection lens, etc. NOTE 2 maximum and, in some cases, may be non-rectangular (for example, an